Effect of Heat Treatment on the Vibration Isolation Performance of Axially Symmetric NiTi Wire Mesh Damper

In this paper, superelastic (SE) NiTi wire is used to fabricate axially symmetric wire mesh dampers (WMDs) with the expectation of a higher damping capacity. However, the phase transformation damping of the NiTi WMD could be suppressed by the cold-work-induced dislocation. Therefore, the NiTi WMDs were heat-treated and then tested by a hydraulic universal testing machine. The NiTi WMD is found to achieve higher damping capacity when heat-treated at 200 °C. However, the WMD heat-treated at 250 °C suffers from a sharp decline in the loss factor in exchange for an improvement in the stiffness. The sine sweep test was then conducted to examine the dependency of the WMD’s vibration isolation performance upon the heat treatment temperature and the excitation acceleration. The NiTi WMD outperforms the 304 stainless steel (SS 304) WMD in damping capacity only when the excitation acceleration magnitude is less than 1.5 g. The stiffness of NiTi WMD can be improved without significantly compromising its damping capacity by heat treatment at 200 °C for 30 min. The present work carries out comprehensive measurements of the NiTi WMD’s response to dynamic mechanical test and sine sweep test and addresses how heat treatment influences the stiffness and damping capacity of the SE NiTi WMD