Investigation into adaptive slicing methodologies for additive manufacturing

Adaptive slicing is a methodology used to optimise the trade-off between build-time reduction and geometric accuracy improvement in additive manufacturing (AM). It works by varying decreasing layer thickness in sections of high curvature. However, current adaptive slicing methodologies all face the difficulty of adjusting layer thickness precisely according to the variations of the model’s geometry, thereby limiting the geometric accuracy improvement. This thesis tackles this difficulty by indicating the geometric variations of the model by evaluating the ratio of the volume of each sliced layer’s geometric deviation to the volume of its corresponding region in the digital model. This indication is accomplished because all the topological information of the corresponding region is considered in assessing the geometric deviation (volume) between each sliced layer and its corresponding region. Through having this precise indication to modify each layer thickness, this thesis aims to develop an adaptive slicing that can mitigate geometric inaccuracies (e.g. staircase effect and dimensional deviation) while balancing the build time. This slicing is evaluated using six different test models, compared with three current slicing methodologies (voxelisation-based, cusp height-based, and uniform slicing), and validated through computation and manufacturing. These validations all demonstrate that volume deviation-based slicing optimises the trade-off between build-time reduction and geometric accuracy improvement better than the other existing slicing methodologies. For example, it can reduce the build time by nearly half compared to other existing slicing methodologies assuming a similar degree of printed parts’ geometric accuracy. The improved trade-off optimised by volume deviation-based slicing can directly benefit the AM applications in the aerospace and medical industries. This is because current research has shown geometric inaccuracies are the primary cause of reducing energy efficiency (e.g. turbine blade and wind tunnel testing models) and having failed implants (e.g. hip and cranial implants, dental prostheses). In addition to improving the geometric accuracy of AM-constructed parts, volume deviation-based slicing may also be incorporated with non-planar layer slicing. Non-planar layer slicing is designed to mitigate the mechanical anisotropy of printed parts by using curved-sliced layers. By integrating volume deviation-based slicing with non-planar layer slicing, the thickness of each curved-sliced layer can be adjusted according to the model’s geometric variations and, therefore, has a possibility of reducing the geometric inaccuracies and mechanical anisotropy simultaneously.Open Acces