Oxide reduction effects in SPS processing of Cu atomized powder containing oxide inclusions

International audienceThe SPS sintering of a commercial copper atomized powder was investigated for analyzing the effects of the oxides reduction reactions on densification and microstructure. This powder, with a mean particle size close to 12 mu m, contains copper oxides (Cu2O mainly) located at the particle surface and inside the particles. Beforehand, the reduction of the oxides was studied by means of TGA, XPS analyses and pressureless sintering in atmosphere containing 4 percent of hydrogen. CuO and Cu2O were reduced at 280 and 425 degrees C respectively. The reduction of Cu2O located inside particles induced the swelling of these latter. The SPS sintering under vacuum did not allow removing the oxides, even using low heating rate during the cycle. Under hydrogen containing atmosphere, the oxide reduction is significant, but requires time, typically through low heating rates, to be efficient. Densification is not achieved in this case because of the development of pores related to the hydrogen sickness phenomenon. No particular effect is observed on neck formation and contacts strengthening. (C) 2016 Elsevier B.V. All rights reserved