Optical link as an alternative for MRI receive coils: toward a passive approach

International audienceObjective: The objective of this work was to propose an alternative solution to NMR signal transmission by replacing the coaxial cables of the receiver radiofrequency (RF) coil in the context of MRI so as to improve safety. Starting from the analysis of previous studies and reports on the topic, the difficulty of supplying power wirelessly to an RF coil was identified. To avoid this difficult task, the development of a passive analog optical link was studied. Methods: In order to quantify the requirements for achieving an analog conversion, the performance of the link was evaluated based on the input NMR signal amplitude and the optical power and compared with that of a galvanic link. Acquisitions were performed on a 7-T preclinical MRI system with a doped saline solution as phantom. A passive and MRI-compatible polarization-state custom-made modulator was tested as well as a commercial Mach–Zehnder interferometer. Results: The conversion was not sensitive enough to keep similar SNRs, but the main source of noise was identified along with parameters for improvement. Optical power emitted by the laser, insertion loss, and full-phase inversion voltage of the modulators were found to be crucial characteristics for the application. These data indicate that custom application devices are required since the frequency, bandwidth, and amplitude of NMR signals are quite different to usual telecommunication signals. Conclusion: An electro-optic modulation and a transmission channel were successfully conceived and tested. Images were reconstructed with some significant SNR drawbacks that are expected to be compensated with an appropriate modulator. Significance: While technical challenges remain, our approach to a two-decades-long problem could solve a major issue of MRI safety by removing the need for supplying on-coil electrical current