Accuracy of Precise Point Positioning (PPP) with the use of different International GNSS Service (IGS) products and stochastic modelling

This paper provides analyses of the accuracy and convergence time of the PPP method using GPS systems and different IGS products. The official IGS products: Final, Rapid and Ultra Rapid as well as MGEX products calculated by the CODE analysis centres were used. In addition, calculations with weighting function of the observations were carried out, depending on the elevation angle. The best results were obtained for CODE products, with a 5-minute interval precision ephemeris and precise corrections to satellite clocks with a 30-second interval. For these calculations the accuracy of position determination was at the level of 3 cm with a convergence time of 44 min. Final and Rapid products, which were orbit with a 15-minute interval and clock with a 5 minute interval, gave very similar results. The same level of accuracy was obtained for calculations with CODE products, for which both precise ephemeris and precise corrections to satellite clocks with the interval of 5 minutes. For these calculations, the accuracy was 4 cm with the convergence time of 70 min. The worst accuracy was obtained for calculations with Ultra-rapid products, with an interval of 15 minutes. For these calculations, the accuracy was 10 cm with a convergence time of 120 min. The use of the weighting function improved the accuracy of position determination in each case, except for calculations with Ultra-rapid products. The use of this function slightly increased the convergence time, in addition to the CODE calculation, which was reduced to 9 min