Effects of scaffold pore morphologies on glucose transport limitations in hollow fibre membrane bioreactor for bone tissue engineering: experiments and numerical modelling

In the current research, three electrospun polycaprolactone (PCL) scaffolds with different pore morphology induced by changing the electrospinning parameters, spinning time and rate, have been prepared in order to provide a fundamental understanding on the effects pore morphology have on nutrient transport behaviour in hollow fibre membrane bioreactor (HFMB). After determining the porosity of the scaffolds, they were investigated for glucose diffusivity using cell culture media (CCM) and distilled water in a diffusion cell at 37 ◦C. The scanning electron microscope (SEM) images of the microstructure of the scaffolds were analysed further using ImageJ software to determine the porosity and glucose diffusivity. A Krogh cylinder model was used to determine the glucose transport profile with dimensionless variables within the HFMB. The paper discusses the roles of various dimensionless numbers (e.g., Péclet and Damköhler numbers) and non-dimensional groups of variables (e.g., non-dimensional fibre radius) on determining glucose concentration profiles, especially in the scaffold region. A negative linear relationship between glucose diffusivities across PCL scaffolds and the minimum glucose concentrations (i.e., concentration on the outer fibre edge on the outlet side (at z = 1 and r = 3.2) was also found. It was shown that the efficiency of glucose consumption improves with scaffolds of higher diffusivities. The results of this study are expected to help in optimizing designs of HFMB as well as carry out more accurate up scaling analyses for the bioreacto