Powder Metallurgical Processing of Sn-Reinforced Al-Cu-Fe Quasicrystals: Structure, Microstructure and Toughening Behavior

The present work deals with powder metallurgical processing of Sn-reinforced Al-Cu-Fe icosahedral quasicrystalline (IQC) composites processed through mechanical milling (MM) followed by hot pressing and pressureless sintering. The structure, microstructure and toughening behavior of the nanocomposite powders and bulk samples were investigated through X-ray diffraction (XRD), optical metallography (OM), scanning electron microscopy (SEM) and indentation techniques. The XRD pattern suggested the coexistence of IQC and λ-Al13Fe4 (mC102; a = 1.549 nm, b = 0.808 nm, c = 1.248 nm) and B2-type Al (Cu, Fe) (cP2; a = 0.29 nm) crystalline phases in milled as well as sintered samples. The face-centered icosahedral (FCI) ordering was persistent even after 40 h of milling and sintering. The structural transformation during MM influences the indentation behavior of IQC-Sn nanocomposite powders, and the microhardness was found to be in the range of ~5.3 to 7.3 GPa. Further, efforts were made to study the indentation behavior of IQC-Sn composite prepared by pressureless sintering and hot pressing. The fracture toughness of the IQC-10Sn hot-pressed sample was found to be ~1.92 MPa.√m, which is ~22% higher than that of the as-cast and annealed IQC. The enhancement in the fracture toughness resulted mainly from the inhibition of cracks by Sn reinforcement particles. This suggests that powder metallurgical processing can produce the IQC-Sn composite with an optimal combination of microhardness and fracture toughness