Analysis of cutting forces at different spindle speeds with straight and helical-flute tools for conventional-speed milling incorporating the effect of tool runout

WOS:000861274800001This paper is concerned with the experimental investigation and mechanistic prediction of cutting forces for flat-end milling with tool runout. The effects of the tool geometry, the workpiece material and cutting parameters such as spindle speed, tool engagement and cutting direction are investigated. The mechanistic force model uses the trochoidal flute path to calculate the undeformed chip thickness. Average cutting force and linear regression model are applied for identifying the coefficients of the force model, and tool runout parameters are established from the radii of all flutes at the free end of the cutting tool. A series of milling processes are conducted on AZ31 Magnesium (Mg) alloy and titanium alloy (Ti6Al4V) to analyze the instantaneous cutting force curves, amplitudes of cutting forces and peak forces over a wide range of conventional spindle speeds, namely 600, 1200 and 3000 rev/min. It is found that the values of the cutting force coefficients are higher at lower spindle speed and decrease with an increase in spindle speed, especially when machining Ti6Al4V alloy. For the edge force coefficients, it is observed a slight variation when using cutting tools with different helix angles. Besides, the cutting force amplitudes strongly depend upon the workpiece material. The helix angle has a significant influence on the transverse force amplitude at the spindle speed of 600 rev/min. The cutting forces obtained mechanistically are also substantiated by comparison with measurements