Add to ORKGNOTES: 1. Upper and lower surfaces of suspended ceiling, between plastic panels, to comply with paragraph 4.1. 2. No restriction on class D-s3, d2 diffusers or rooflights in small rooms. 3. See note 4 to Table 4.2. 5m² See Table 4.
Thermoplastic materials used for window glazing, rooflights and lighting diffusers within suspended ...
Particular attention is drawn to the following points. a. Membranes used as part of the external w...
For the purposes of this requirement, a ceiling does not include any of the following. a. Trap door...
Materials within this zone – at plane of ceiling – should comply with Table 4.1 Rooflights See Tab...
NOTES: 1. This table does not apply to products that meet the provisions in Table 4.1. 2. Smaller ...
NOTES: 1.There are restrictions on the use of plastic rooflights in the guidance to requirement B2 ...
NOTES: None of the above designations are suitable for protected stairways. Polycarbonate and uPVC...
Table 12.2 and Diagram 12.1 set the limitations for using plastic rooflights whose lower surface has...
Diffusers constructed of thermoplastic material may be incorporated in ceilings to rooms and circula...
In rooms and circulation spaces other than protected stairways, rooflights may be constructed of the...
NOTES: Separation distances do not apply to the boundary between roofs of a pair of semi-detached d...
a. DIFFUSER FORMING PART OF CEILING b. DIFFUSER IN FITTING BELOW AND NOT FORMING PART OF CEILING S...
To reduce the risk of fire spreading over the roof from one compartment to another, a 1500mm wide zo...
Regulation 7(2) requires that the curtain and or slats of solar shading devices in a relevant buildi...
Provisions for the fire properties of roofs are given in other parts of this document. a. Requireme...
Thermoplastic materials used for window glazing, rooflights and lighting diffusers within suspended ...
Particular attention is drawn to the following points. a. Membranes used as part of the external w...
For the purposes of this requirement, a ceiling does not include any of the following. a. Trap door...
Materials within this zone – at plane of ceiling – should comply with Table 4.1 Rooflights See Tab...
NOTES: 1. This table does not apply to products that meet the provisions in Table 4.1. 2. Smaller ...
NOTES: 1.There are restrictions on the use of plastic rooflights in the guidance to requirement B2 ...
NOTES: None of the above designations are suitable for protected stairways. Polycarbonate and uPVC...
Table 12.2 and Diagram 12.1 set the limitations for using plastic rooflights whose lower surface has...
Diffusers constructed of thermoplastic material may be incorporated in ceilings to rooms and circula...
In rooms and circulation spaces other than protected stairways, rooflights may be constructed of the...
NOTES: Separation distances do not apply to the boundary between roofs of a pair of semi-detached d...
a. DIFFUSER FORMING PART OF CEILING b. DIFFUSER IN FITTING BELOW AND NOT FORMING PART OF CEILING S...
To reduce the risk of fire spreading over the roof from one compartment to another, a 1500mm wide zo...
Regulation 7(2) requires that the curtain and or slats of solar shading devices in a relevant buildi...
Provisions for the fire properties of roofs are given in other parts of this document. a. Requireme...
Thermoplastic materials used for window glazing, rooflights and lighting diffusers within suspended ...
Particular attention is drawn to the following points. a. Membranes used as part of the external w...
For the purposes of this requirement, a ceiling does not include any of the following. a. Trap door...