In vitro effect of different implant decontamination methods in three intraosseous defect configurations

Objectives This in vitro investigation was aimed to evaluate the cleaning ability of four mechanical devices designed for decontaminating implant surfaces. Material and methods Ninety-six implants were coated with permanent ink and inserted into 3D-printed resin blocks simulating three different intraosseous defect configurations (types Ib, Ic, and Ie). The four tested mechanical decontamination devices (air-polishing with glycine powder, rotating titanium brush, polyetheretherketone [PEEK]-coated ultrasonic tip, and stainless steel ultrasonic tip) were randomly applied onto the 5 mm exposed implant surface. Standardized photographs were taken from a frontal perspective and with a 30° angle coronally and apically to the implant axis. The area with remnant ink on the implant surface was calculated. Results Although none of the groups achieved complete ink removal, air-polishing with glycine and titanium brushes demonstrated a higher cleaning ability when compared with ultrasonic devices either with standard or PEEK tips for all three defect configurations. For the three tested models, the best cleaning ability in all groups was shown on implant surfaces without facing an intraosseous wall. Titanium brush was the most effective when the intraosseous walls existed. Cleaning effectiveness diminished in the threads located in the apical third, especially when using air-polishing and ultrasonic devices. Conclusions Titanium brushes and air-polishing devices were more effective in removing artificial biofilm using this in vitro model, although their effectiveness was influenced by the presence of the intrabony component