Does the Translucency of Novel Monolithic CAD/CAM Materials Affect Resin Cement Polymerization with Different Curing Modes?

Purpose The translucency of CAD/CAM blocks influences the polymerization efficiency of resin cement used underneath. The aim of this study is to evaluate the influence of the translucency parameters (TPs) of current monolithic CAD/CAM blocks on the microhardness of light-cured or dual-cured resin cement. Materials and Methods 100 specimens were prepared from five types of CAD/CAM blocks (Mark II, Suprinity, Enamic, e.max, Ultimate), and their TP values were measured by spectrophotometry; 100 resin cement specimens (Duolink) were cured underneath five ceramic specimen groups by indirect LED light for 40 seconds with dual-cure (with catalyst) and light-cure (without catalyst) polymerization modes. Control group resin cement specimens (n = 20) were cured with both polymerization modes by direct LED light without any ceramic disc, making 120 resin cement specimens in total. The specimens were then stored in a dry environment for 24 hours before measurement of the polymerization depth with a digital micrometer. Vickers hardness measurements were performed at different resin cement sections. The results were statistically analyzed with 1-, 2-, and 3-way ANOVA, Student's t-test and Tukey's HSD test (alpha = 0.05). Results The highest TP values occurred for Suprinity and Ultimate, whereas the lowest TP value occurred for Enamic (p 0.05). In Enamic, the hardness values for both polymerization types decreased significantly in the deeper sections (p < 0.01). Conclusions Lower depth of cure was observed as the amount of transmitted light decreased in the investigated materials. In clinical practice, light-cured resin cements may result in inadequate polymerization for ceramic materials with lower TP values. Zirconia-reinforced lithium silicate and nanoceramic resins may be reliable restorative materials for a restoration with both optimal esthetics and sufficient mechanical strength resulting from proper polymerization