Add to ORKGSupercritical CO2 power generation cycles are being developed for cleaner and high efficiency combustion. For these systems to be designed, the chemical kinetics of combustion must be well understood at their operating regimes which are typically very high-pressure conditions. In this study, experiments were performed behind reflected shockwaves to measure the ignition delay times for methane and hydrogen in CO2 diluted environments at around 40 atmospheres. The temperature ranges were between 1325K to 1600 K for methane and 1150K to 1330K for hydrogen, respectively. Based on the data, Aramco 2.0 mechanism and GRI 3.0 mechanism are approximately modelling the ignition delay times of methane combustion, however, are unable to predict the ign...
Shock-tube ignition delay time experiments and chemical kinetics model calculations were performed f...
Understanding the experimental data from shock tubes can be complicated when non-idealities such as ...
Reduced mechanisms are needed for use with computational fluid dynamic codes (CFD) utilized in the d...
Direct-fired supercritical CO2 power cycles, operating on natural gas or syngas, have been proposed ...
Although concerns about carbon dioxide (CO2) emissions and their impact on climate change has led to...
Ignition delay times and methane species time-histories were measured for methane/O2 mixtures in a h...
Ignition delay times and methane species time-histories were measured for methane/O2 mixtures in a h...
This paper presents ignition delay times of methane oxidation diluted with carbon dioxide and argon....
In this study, syngas combustion was investigated behind reflected shock waves in CO2 bath gas to me...
The combustion of methane in air results in large amounts of CO2 and NOX emissions. In order to redu...
Direct fired supercritical CO2 (sCO2) power cycles allow for the combustion of gaseous fuels under o...
Pressurized oxy-fuel combustion is regarded as a new generation of oxy-fuel technology. The ignition...
This thesis reports methane (CH4) and a syngas mixture (H2/CO=95:5) autoignition delay measurements ...
Common definitions for ignition delay time are often hard to determine due to the issue of bifurcati...
International audienceA high pressure shock tube "HPST" has been designed and validated for the purp...
Shock-tube ignition delay time experiments and chemical kinetics model calculations were performed f...
Understanding the experimental data from shock tubes can be complicated when non-idealities such as ...
Reduced mechanisms are needed for use with computational fluid dynamic codes (CFD) utilized in the d...
Direct-fired supercritical CO2 power cycles, operating on natural gas or syngas, have been proposed ...
Although concerns about carbon dioxide (CO2) emissions and their impact on climate change has led to...
Ignition delay times and methane species time-histories were measured for methane/O2 mixtures in a h...
Ignition delay times and methane species time-histories were measured for methane/O2 mixtures in a h...
This paper presents ignition delay times of methane oxidation diluted with carbon dioxide and argon....
In this study, syngas combustion was investigated behind reflected shock waves in CO2 bath gas to me...
The combustion of methane in air results in large amounts of CO2 and NOX emissions. In order to redu...
Direct fired supercritical CO2 (sCO2) power cycles allow for the combustion of gaseous fuels under o...
Pressurized oxy-fuel combustion is regarded as a new generation of oxy-fuel technology. The ignition...
This thesis reports methane (CH4) and a syngas mixture (H2/CO=95:5) autoignition delay measurements ...
Common definitions for ignition delay time are often hard to determine due to the issue of bifurcati...
International audienceA high pressure shock tube "HPST" has been designed and validated for the purp...
Shock-tube ignition delay time experiments and chemical kinetics model calculations were performed f...
Understanding the experimental data from shock tubes can be complicated when non-idealities such as ...
Reduced mechanisms are needed for use with computational fluid dynamic codes (CFD) utilized in the d...