Temporal and spatial variation in the efficiency of a Floc & Sink technique for controlling cyanobacterial blooms in a tropical reservoir

One of the main symptoms of eutrophication is the proliferation of phytoplankton biomass, including nuisance cyanobacteria. Reduction of the external nutrient load is essential to control eutrophication, and in-lake interventions are suggested for mitigating cyanobacterial blooms to accelerate ecosystem recovery. Floc & Sink (F&S) is one such intervention technique that consists of applying a low dose of coagulants in combination with ballasts for removing cyanobacteria biomass. It is especially suitable for deep lakes with an external nutrient load that is higher than the internal load and suffers from perennial cyanobacterial bloom events. Studies showing the efficacy of the F&S technique have been published, but those testing its variation in efficacy with changes in the environmental conditions are still scarce. Therefore, we evaluated the efficiency of the F&S technique to remove cyanobacteria from water samples collected monthly from two different sites in a deep tropical reservoir (Funil Reservoir, Brazil) in the laboratory. We tested the efficacy of two coagulants, chitosan (CHI) and poly-aluminum chloride (PAC), alone and in combination with lanthanum-modified bentonite (LMB) in settling phytoplankton biomass. We hypothesized that: ⅰ) the combined treatments are more effective in removing the algal biomass and ⅱ) the efficiency of F&S treatments varies spatially and monthly due to changes in environmental conditions. The combined treatments (PAC + LMB or CHI + LMB) removed up to seven times more biomass than single treatments (PAC, CHI, or LMB). Only the treatments CHI and LMB + CHI differed in efficiency between the sites, although all treatments showed significant variation in efficiency over the months at both the sampling sites. The combined treatments exhibited lower removal efficacy during the warm-rainy months (October–March) than during the mild-cold dry months (April–September). At high pH (pH > 10), the efficiency of the CHI and LMB + CHI treatments decreased. CHI had lower removal efficiency when single-cell cyanobacteria were abundant, while the combined treatments were equally efficient regardless of the morphology of the cyanobacteria. Hence, the combination of PAC as a coagulant with a ballast LMB is the most effective technique to precipitate cyanobacteria under the conditions that are encountered around the year in this tropical reservoir