Hydrogeology of the Colli Albano volcano

This study, based on numerous investigations previously conducted by the Authors, was carried out for different purposes, in the field of water resource management. The hydrogeological setting of the Colli Albani Volcano was defined by using a large stratigraphic data base, whose data were processed with GIS and numerical aquifer modelling methodologies. The process made it possible to reconstruct the fundamental geological surfaces and, from them, the local hydrogeological complexes. The complexes were then associated with permeability values obtained from in-hole hydraulic tests. After numerous surveys, detailed piezometric maps were built. The maps describe the morphology of the top of the saturated zone referred to the basal groundwater system. Based on the geometry obtained, the “Colli Albani” Hydrogeological Unit has been subdivided in hydrogeological basins. In the Colli Albani area, streams (especially in their terminal section) are in close relationships with groundwater. Under natural conditions, these relationships control the flow of groundwater towards the catchment area. At present, however, lowering of saturation levels is causing a sharp decrease in stream-bed discharge and often a reversal of the directions of groundwater flow. Water budgets were computed for the overall hydrogeological system and for each hydrogeological basin. The computations considered not only the natural parameters of outflows and inflows to/from the hydrogeological system, but also those of human activities having a major impact on aquifer recharge. So far, water withdrawal from the two basins has exceeded the availability of and strongly depleted the local renewable water resources. The paper also presents maps describing the physico-chemical characteristics of groundwater in the study area and the isopleths of their electrical conductivity and temperature values