Set-up and calibration of a method to measure 10B concentration in biological samples by neutron autoradiography

A selective uptake of boron in the tumor is the base of Boron Neutron Capture Therapy, which can destroy the tumor substantially sparing the normal tissue. In order to deliver a lethal dose to the tumor, keeping the dose absorbed by normal tissues below the tolerance level, it is mandatory to know the 10B concentration present in each kind of tissue at the moment of irradiation. This work presents the calibration procedure adopted for a boron concentration measurement method based on neutron autoradiography, where biological samples are deposited on sensitive films and irradiated in the thermal column of the TRIGA reactor (University of Pavia). The latent tracks produced in the film by the charged particles coming from the neutron capture in 10B are made visible by a proper etching, allowing the measurement of the track density. A calibration procedure with standard samples provides curves of track density as a function of boron concentration, to be used in the measurement of biological samples. In this paper, the bulk etch rate parameter and the calibration curves obtained for both liquid samples and biological tissues with known boron concentration are presented. A bulk etch rate value of (1.64 \ub1 0.02) \u3bcm/h and a linear dependence with etching time were found. The plots representing the track density versus the boron concentration in a range between 5 and 50 \u3bcg/g (ppm) are linear, with an angular coefficient of (1.614 \ub1 0.169)\ub710 123 tracks/(\u3bcm2 ppm) for liquids and (1.598 \ub1 0.097)\ub710 122 tracks/(\u3bcm2 ppm) for tissues