Add to ORKGIn this paper the main results from the industrial comparison "VideoAUDIT" are presented and discussed. The comparison, designed and coordinated by the Laboratory of Industrial and Geometrical Metrology of the University of Padova, involved 21 optical CMMs from various companies in Europe (Italy, Switzerland, Spain and Denmark). The comparison was run between August 2007 and January 2009. The participants were given the opportunity to verify the metrological performances of their CMMs with suited artefacts and procedures. Based on the comparison results, the actual quality of industrial optical measurements was evaluated
This research focuses on the characterization of the metrology of Optical 3D Coordinate Measurement ...
The current sets of internationally-recognized standards and some national guidelines in the area of...
AbstractIn this paper, a laser interferometer was used to evaluate the linear performance of an opti...
The main results of an industrial inter-laboratory comparison for CMMs equipped with optical sensors...
The main results of an industrial inter-laboratory comparison for CMMs equipped with optical sensors...
An increasing number of manufactured parts are measured in industry using non-contact measuring syst...
Optical dimensional measuring techniques are increasingly used for quality control across many indus...
Optical dimensional measuring techniques are increasingly used for quality control across many indus...
The reason for the writing of this thesis is to compare two different ways of quality control – opti...
At the state-of-the-art, the use of Coordinate Measuring Systems (CMS) for verification of geometric...
The paper presents an investigation on procedures and artefacts for testing the metrological perform...
AbstractThe coordinate measuring machines (CMM's) has given a new impulse in the field of geometrica...
Optical coordinate measuring systems are gaining increasing interest in production quality control, ...
Optical coordinate measuring systems are gaining increasing interest in production quality control, ...
This graduation work is about co-ordinal measuring machines (CMM) with optical reader system and opt...
This research focuses on the characterization of the metrology of Optical 3D Coordinate Measurement ...
The current sets of internationally-recognized standards and some national guidelines in the area of...
AbstractIn this paper, a laser interferometer was used to evaluate the linear performance of an opti...
The main results of an industrial inter-laboratory comparison for CMMs equipped with optical sensors...
The main results of an industrial inter-laboratory comparison for CMMs equipped with optical sensors...
An increasing number of manufactured parts are measured in industry using non-contact measuring syst...
Optical dimensional measuring techniques are increasingly used for quality control across many indus...
Optical dimensional measuring techniques are increasingly used for quality control across many indus...
The reason for the writing of this thesis is to compare two different ways of quality control – opti...
At the state-of-the-art, the use of Coordinate Measuring Systems (CMS) for verification of geometric...
The paper presents an investigation on procedures and artefacts for testing the metrological perform...
AbstractThe coordinate measuring machines (CMM's) has given a new impulse in the field of geometrica...
Optical coordinate measuring systems are gaining increasing interest in production quality control, ...
Optical coordinate measuring systems are gaining increasing interest in production quality control, ...
This graduation work is about co-ordinal measuring machines (CMM) with optical reader system and opt...
This research focuses on the characterization of the metrology of Optical 3D Coordinate Measurement ...
The current sets of internationally-recognized standards and some national guidelines in the area of...
AbstractIn this paper, a laser interferometer was used to evaluate the linear performance of an opti...