A first appraisal of the seismogenic and tsunamigenic potential of the largest fault systems in the westernmost Mediterranean

15 pages, 10 figures, 3 tables, supplementary material https://doi.org/10.1016/j.margeo.2022.106749.-- Data availability: The data (3D complex mesh of the ARFS and rake values, and the resulting grid files of the tsunami simulations containing the maximum wave amplitude) are archived at PANGAEA repository (https://doi.pangaea.de/10.1594/PANGAEA.941092).-- The EMODnet bathymetry is available at https://www.emodnet-bathymetry.eu/. The stochastic slip distributions have been produced by the code ANTI-FASc (https://github.com/antonioscalaunina/ANTI-FASc) a platform partially based on the code k223d (Herrero and Murphy, 2018 available at https://github.com/s-murfy/k223d), in turn based on the slipk2 (available at https://github.com/andherit/slipk2) and the trilateration codes (available at https://github.com/andherit/trilateration)The westernmost Mediterranean hosts part of the plate boundary between the European and African tectonic plates. Based on the scattered instrumental seismicity, this boundary has been traditionally interpreted as a wide zone of diffuse deformation. However, recent seismic images and seafloor mapping studies support that most of the plate convergence may be accommodated in a few tectonic structures, rather than in a broad region. Historical earthquakes with magnitudes Mw > 6 and historical tsunamis support that the low-to-moderate instrumental seismicity might also have led to underestimation of the seismogenic and tsunamigenic potential of the area. We evaluate the largest active faults of the westernmost Mediterranean: the reverse Alboran Ridge, and the strike-slip Carboneras, Yusuf and Al-Idrissi fault systems. For the first time, we use a dense grid of modern seismic data to characterize the entire dimensions of the main fault systems, accurately describe the geometry of these structures and estimate their seismic source parameters. Tsunami scenarios have been tested based on 3D-surfaces and seismic source parameters, using both uniform and heterogeneous slip distributions. The comparison of our results with previous studies, based on limited information on the fault geometry and kinematics, indicates that accurate fault geometries and heterogeneous slip distributions are needed to properly assess the seismic and tsunamigenic potential in this area. Based on fault scaling relations, the four fault systems have a large seismogenic potential, being able to generate earthquakes with Mw > 7. The reverse Alboran Ridge Fault System has the largest tsunamigenic potential, being able to generate a tsunami wave amplitude greater than 3 m in front of the coasts of Southern Spain and Northern AfricaThis work is supported by the Cluster of Excellence “The Future Ocean”, within the framework of the Excellence Initiative by the Deutsche Forschungsgemeinschaft (DFG) on behalf of the German federal and state governments. This study benefited from an EU Marie Skłodowska-Curie Individual Fellowship to LGP (H2020-MSCA-IF-2017 796013). LGP, CS, FM and RB acknowledge the resources made available by the SISMOLAB-3D at INGV. This work has been carried out in collaboration with the Grup de Recerca Consolidat de la Generalitat de Catalunya “Barcelona Center for Subsurface Imaging” (2017 SGR 1662), and acknowledges the ICM “Severo Ochoa Centre of Excellence” accreditation (CEX2019-000928-S)Peer reviewe