TI: Compatibilization of PA6/rubber blends by using an oxazoline functionalized rubber

The compatibilization of blends of polyamide 6 with a nitrile butadiene rubber has been investigated. The procedure consists of two steps: modification of the nitrile groups of the rubber into oxazoline in the melt through condensation of ethanolamine with formation of a molecule of ammonia, followed by use of the modified rubber as a compatibilizing precursor which is melt mixed with the polyamide to produce the compatibilized blend. The modification reaction has been detected by NMR analysis and a rheological, mechanical and thermomechanical characterization has been carried out on the all the blends. The results indicate that the modification reaction occurs but the conversion of nitrile into oxazoline is relatively low. Use of the modified rubber in the preparation of binary polyamide/rubber blends, leads to an increase in viscosity, which is typical of compatibilized systems, and to enhanced tensile, impact and thermomechanical properties. These phenomena can be explained by the formation of in situ rubber/polyamide copolymers that act as compatibilizers, due to the reaction between oxazoline and the end groups of the polyamide. The presence of residual low molecular compounds, from the modification or from the purification of the rubber worsens all of the properties and inhibits the compatibilizing effect of the modified rubber