Feedback Noise Propagation in Multisampled DC-DC Power Electronic Converters

This article analyzes the propagation of feedback noise in multisampled dc-dc power converters. The analytical calculations for noise attenuation, strictly valid for linear time-invariant systems, are found to offer good predictions for power converters, after suppressing the decimation effects of the digital pulsewidth modulator (DPWM). For control systems that employ a proportional-integral controller, without any digital low-pass filters, the nonlinearity caused by the DPWM decimation is found to saturate the noise attenuation properties, as the multisampling factor N is increased. Strong noise attenuation is enabled using antialiasing digital filters, with a small impact on the dynamic response. For control systems that employ a proportional-integral-derivative controller, increase of the multisampling factor, without any digital filters, causes the amplification of the noise power. Therefore, a greater attenuation of high-frequency components is required to provide a significant noise reduction in the control bandwidth. Even with these antialiasing digital filters, the dynamic response of multisampled control systems is improved compared to double-update. This is proven by the analytical and experimental comparison of various multisampled control strategies in terms of dynamic response and noise attenuation capabilities. The experimental results, from a buck-type converter, match well with simulations and analytical calculations