FPGA Implementation of Fast Fourier Transform Core Using NEDA

Transforms like DFT are a major block in communication systems such as OFDM, etc. This thesis reports architecture of a DFT core using NEDA. The advantage of the proposed architecture is that the entire transform can be implemented using adder/subtractors and shifters only, thus minimising the hardware requirement compared to other architectures. The proposed design is implemented for 16-bit data path (12–bit for comparison) considering both integer representation as well as fixed point representation, thus increasing the scope of usage. The proposed design is mapped on to Xilinx XC2VP30 FPGA, which is fabricated using 130 nm process technology. The maximum on board frequency of operation of the proposed design is 122 MHz. NEDA is one of the techniques to implement many signal processing systems that require multiply and accumulate units. FFT is one of the most employed blocks in many communication and signal processing systems. The FPGA implementation of a 16 point radix-4 complex FFT is proposed. The proposed design has improvement in terms of hardware utilization compared to traditional methods. The design has been implemented on a range of FPGAs to compare the performance. The maximum frequency achieved is 114.27 MHz on XC5VLX330 FPGA and the maximum throughput, 1828.32 Mbit/s and minimum slice delay product, 9.18. The design is also implemented using synopsys DC synthesis in both 65 nm and 180 nm technology libraries. The advantages of multiplier-less architectures are reduced hardware and improved latency. The multiplier-less architectures for the implementation of radix-2^2 folded pipelined complex FFT core are based on NEDA. The number of points considered in the work is sixteen and the folding is done by a factor of four. The proposed designs are implemented on Xilinx XC5VSX240T FPGA. Proposed designs based on NEDA have reduced area over 83%. The observed slice-delay product for NEDA based designs are 2.196 and 5.735