Blade tip timing to determine turbine blade fatigue in high backpressure conditions

This dissertation presents an approach to use blade tip timing measurements with finite element analysis to predict the fatigue life of a low pressure steam turbine last stage blade under high backpressure and low flow conditions. Material fatigue properties were determined through the extended universal material law for FV566 material, along with different temper scenarios. A finite element model of a blade with damping pins was developed, using the principle of cyclic symmetry for a perfectly tuned model. Pre-stress modal analysis was conducted, incorporating damping via friction and plasticity for initial 20% overspeed test. The finite element model was verified by two experimental tests: the first being a blade impact test and the second a telemetry strain gauge test in a balance pit. Fatigue life analysis was conducted under the assumption that non-synchronous vibration is experienced by the blade and that only one mode is dominant in the vibration. The results from the fatigue analysis corresponded to the location of the cracks experienced on the blades. The results show twelve orders of magnitude lower life at low load, high backpressure conditions, compared to high load high pressure conditions. The research was further extended to check the same vibratory response on the first three modes, up to their tenth nodal diameters. This was done to analyse fatigue life in a case that a different mode was excited.Dissertation (MEng)--University of Pretoria, 2020.Eskom Rotek IndustriesMechanical and Aeronautical EngineeringMEngUnrestricte