Measuring the overall volumetric heat transfer coefficient in a vapour-liquid-liquid three-phase direct contact heat exchanger

An experimental investigation of the volumetric heat transfer coefficient in a three-phase direct contact condenser was carried out. A 75-cm long cylindrical Perspex column with a 4 cm diameter was used. Only 48 cm of the column was utilised as the active direct contact condensation height. Pentane vapour at three different initial temperatures (40°C, 43.5°C and 47.5°C), with differing mass flow rates, and tap water at a constant initial temperature (19°C) with five different mass flow rates were employed as the dispersed phase and the continuous phases, respectively. The results showed that the volumetric heat transfer coefficient increased with increasing mass flow rate ratio (variable dispersed phase mass flow rate per constant continuous phase mass flow rate), the continuous phase mass flow rate and holdup ratio. An optimal value of the continuous phase mass flow rate is shown for an individual dispersed phase mass flow rates. This value increases with increasing vapour (dispersed) phase mass flow rate. Furthermore, it was observed that the initial driving temperature difference had no effect on the volumetric heat transfer coefficient. While, the temperature gained by the continuous phase has a considerable effect