Virtual commissioning of the robotic completion of the shaft

This diploma thesis deals with the design and virtual commissioning of a robotic workplace for the assembly of an electric motor shaft. The theoretical part of the thesis summarizes the knowledge about virtual commissioning and briefly introduces the simulation program Process Simulate from the Tecnomatix software family. The practical part describes the design of a new robotic workplace for pre-assembly of rotors, which is to replace the three workplaces of manual assembly. The design was made on the basis of an analysis of the current state of the manual assembly process and using multicriteria analysis. The next section describes the process of creating a simulation model in the Process Simulate program and creating a PLC control program for a robotic cell in the TIA Portal program. The work also contains a proposal for the visualization of the HMI control panel using the HMI Template Suite. At the end of the work is a description of the virtual commissioning itself