This article compares two instruments for the traceable measurement of dc low currents, a custom capacitance-voltage (C-V) source and the ultrastable low-current amplifier (ULCA), a commercial precision transresistance amplifier. The instruments are calibrated through independent traceability routes. The comparison base relative accuracy is in the 10(-6)-10(-5) range. Differences between the two instrument readings, in the 10(-5) range, are interpreted as an effect of the frequency dependence of the capacitor employed in the C-Vsource. Such frequency dependence can also affect primary metrology experiments in other fields
This paper describes the methodology used to achieve the AC voltage traceability and the associated ...
Contactless capacitive (open-air) sensors are applied to monitor overvoltages near overhead line ter...
This paper deals with the measurement of low values of electrical voltages and currents from sources...
We describe a setup for the calibration of the transresistance gain of low-current amplifiers, based...
Capacitance measurements at the National Institute of Standards (NIS), Egypt, are traceable to the B...
Modern commercial dc current transformers (DCCTs) can measure currents up to the kiloampere range wi...
We present a capacitance build-up method suitable for the determination of the measurement error of ...
Main text The intercomparison consisted of calibrating the capacitance and loss factor (tan δ) of a ...
A new reference resistive-capacitive voltage divider is presented in this paper, operating in DC and...
The Italian national standard of direct current is being extended down to the femtoampere range. Two...
We report a new technique for the rapid measurement of full capacitance-voltage (C-V) characteristic...
During the AC impedance characterization of devices, from the kHz-range up to the GHz-range, accurac...
Capacitance boxes (CBs) are extensively used in electrical laboratories for calibration of capacitan...
In the last few years several new digital methods have been developed for capacitance ...
The use of capacitive dividers (CDs) in medium-voltage (MV) networks started as simple voltage detec...
This paper describes the methodology used to achieve the AC voltage traceability and the associated ...
Contactless capacitive (open-air) sensors are applied to monitor overvoltages near overhead line ter...
This paper deals with the measurement of low values of electrical voltages and currents from sources...
We describe a setup for the calibration of the transresistance gain of low-current amplifiers, based...
Capacitance measurements at the National Institute of Standards (NIS), Egypt, are traceable to the B...
Modern commercial dc current transformers (DCCTs) can measure currents up to the kiloampere range wi...
We present a capacitance build-up method suitable for the determination of the measurement error of ...
Main text The intercomparison consisted of calibrating the capacitance and loss factor (tan δ) of a ...
A new reference resistive-capacitive voltage divider is presented in this paper, operating in DC and...
The Italian national standard of direct current is being extended down to the femtoampere range. Two...
We report a new technique for the rapid measurement of full capacitance-voltage (C-V) characteristic...
During the AC impedance characterization of devices, from the kHz-range up to the GHz-range, accurac...
Capacitance boxes (CBs) are extensively used in electrical laboratories for calibration of capacitan...
In the last few years several new digital methods have been developed for capacitance ...
The use of capacitive dividers (CDs) in medium-voltage (MV) networks started as simple voltage detec...
This paper describes the methodology used to achieve the AC voltage traceability and the associated ...
Contactless capacitive (open-air) sensors are applied to monitor overvoltages near overhead line ter...
This paper deals with the measurement of low values of electrical voltages and currents from sources...