Add to ORKGThis paper presents a baseline vector measurement technique using a two-channel GPS software receiver. The relative phases between the two channels were measured against satellites. An algorithm is proposed to solve the baseline vector. The ambiguity is resolved through searching for the possible solutions which meets certain pre-specified criterions
The key processing algorithms for GPS software receiver are introduced and the signal acquisition, t...
This paper addresses the problem of determining the baseline of formation flying satellites using ca...
Forward collision warning systems, lane change assistants or cooperative adaptive cruise control are...
GNSS noise characteristics can be obtained by short and zero baseline analysis, for both pseudorange...
Abstract: A detailed algorithm for GPS baseline processing using phase observations is presented in ...
This paper deals with the problem of determining the baseline vector between two GPS receivers in si...
For Global Navigation Satellite System (GNSS) single frequency, single epoch attitude determination,...
iii This thesis presents an approach to combine GPS and GLONASS measurements, using a single differe...
GNSS attitude determination has been widely used in various navigation and positioning applications,...
To perform the most precise relative positioning using GPS, it is necessary to resolve the carrier-p...
If three or more GPS antennas are mounted properly on a platform and differences of GPS signals meas...
This paper presents a novel approach to combining GPS and GLONASS to estimate heading and pitch usin...
In aviation, satellite navigation is generally only used to determine the absolute position of aircr...
The use of Global Positioning System (GPS) measurements provides the primary technique for determini...
The performance of the Global Navigation Satellite System (GNSS) compass is related to the quality o...
The key processing algorithms for GPS software receiver are introduced and the signal acquisition, t...
This paper addresses the problem of determining the baseline of formation flying satellites using ca...
Forward collision warning systems, lane change assistants or cooperative adaptive cruise control are...
GNSS noise characteristics can be obtained by short and zero baseline analysis, for both pseudorange...
Abstract: A detailed algorithm for GPS baseline processing using phase observations is presented in ...
This paper deals with the problem of determining the baseline vector between two GPS receivers in si...
For Global Navigation Satellite System (GNSS) single frequency, single epoch attitude determination,...
iii This thesis presents an approach to combine GPS and GLONASS measurements, using a single differe...
GNSS attitude determination has been widely used in various navigation and positioning applications,...
To perform the most precise relative positioning using GPS, it is necessary to resolve the carrier-p...
If three or more GPS antennas are mounted properly on a platform and differences of GPS signals meas...
This paper presents a novel approach to combining GPS and GLONASS to estimate heading and pitch usin...
In aviation, satellite navigation is generally only used to determine the absolute position of aircr...
The use of Global Positioning System (GPS) measurements provides the primary technique for determini...
The performance of the Global Navigation Satellite System (GNSS) compass is related to the quality o...
The key processing algorithms for GPS software receiver are introduced and the signal acquisition, t...
This paper addresses the problem of determining the baseline of formation flying satellites using ca...
Forward collision warning systems, lane change assistants or cooperative adaptive cruise control are...