Add to ORKGThe objective of this project was to develop a software package that would allow more efficient, accurate, and easier use of wind tunnel data. The software was to receive an analog signal from an array of hot wire anemometers, convert the signal to a digital format, and then process the raw data, converting it into values of properties which have practical value to the user. Unfortunately, due to scheduling conflicts, this project never left the software development stage. The user interface was successfully designed. The signal conversion portion of the package was not completed and the package was never tested
The objective of this thesis is to apply high frequency flow measurement technique known as hot wi...
Traditionally, the measurement of turbulence has been conducted using hot-wire anemometry. This thes...
This paper presents the evaluation of the characteristics of the open-loop low-speed UNNE Wind Tunne...
The very first objective of performing most experiments is collecting numerical data. Values can be ...
The research presented here focuses on the development of a 3D printed wind tunnel and the relevant ...
A vane type anemometer was developed as a secondary standard for the on site calibration of wind vel...
The need to reduce time and cost of running high speed (transonic & supersonic) wind tunnels and...
The Langley Research Center has a concentrated and directed effort under way to develop both convent...
Abstract: The wind tunnel development with wind speed control is presented in this paper using an ul...
The research presented here focuses on the development of a 3D printed wind tunnel and the relevant ...
This thesis describes the advantages of replacing a three cup anemometer and wind vane for a sonic a...
Calibration tests using hot wires were conducted using a newly developed test rig that greatly reduc...
This paper presents the experimental three-year learning activity developed by a group of teachers i...
Dept. of Mechanical, Automotive, and Materials Engineering. Paper copy at Leddy Library: Theses & Ma...
The study of naturally occurring turbulent flows requires ability to collect empirical data down to ...
The objective of this thesis is to apply high frequency flow measurement technique known as hot wi...
Traditionally, the measurement of turbulence has been conducted using hot-wire anemometry. This thes...
This paper presents the evaluation of the characteristics of the open-loop low-speed UNNE Wind Tunne...
The very first objective of performing most experiments is collecting numerical data. Values can be ...
The research presented here focuses on the development of a 3D printed wind tunnel and the relevant ...
A vane type anemometer was developed as a secondary standard for the on site calibration of wind vel...
The need to reduce time and cost of running high speed (transonic & supersonic) wind tunnels and...
The Langley Research Center has a concentrated and directed effort under way to develop both convent...
Abstract: The wind tunnel development with wind speed control is presented in this paper using an ul...
The research presented here focuses on the development of a 3D printed wind tunnel and the relevant ...
This thesis describes the advantages of replacing a three cup anemometer and wind vane for a sonic a...
Calibration tests using hot wires were conducted using a newly developed test rig that greatly reduc...
This paper presents the experimental three-year learning activity developed by a group of teachers i...
Dept. of Mechanical, Automotive, and Materials Engineering. Paper copy at Leddy Library: Theses & Ma...
The study of naturally occurring turbulent flows requires ability to collect empirical data down to ...
The objective of this thesis is to apply high frequency flow measurement technique known as hot wi...
Traditionally, the measurement of turbulence has been conducted using hot-wire anemometry. This thes...
This paper presents the evaluation of the characteristics of the open-loop low-speed UNNE Wind Tunne...