Design of a Bearingless Permanent Magnet Synchronous Machine with a Star Point-Connected Axial Active Magnetic Bearing

The bearingless synchronous machine is considered with slotted stator, cylindrical rotor with sleeve-protected surface-mounted permanent magnets and six actively controlled degrees of freedom as high-speed drive. The focus is set on two key aspects: The machine design under consideration of size-dependent scaling effects and a novel kind of feeding the excitation winding of the axial active magnetic bearing. Since the considered bearingless PM machines typically exhibit a low degree of magnetic saturation and are equipped with distributed windings, the two-dimensional analytical calculation is used to calculate the rotor suspension force and disturbing rotor forces. These calculations are used in the subsequent electromagnetic design process. At the beginning of the design process, boundary conditions are discussed, that are derived geometrically for the combined drive and suspension winding, structural mechanically for the sleeve height and thermally for the loss and output power density. On the basis of two different machine sizes, on the one hand approximately 1.5 kW and on the other hand approximately 60 kW at 75 mm and 130 mm outer diameter, respectively, at corresponding active axial length of 40 mm and 125 mm, this work shows, how the choice of pole count, bore diameter and magnet height influences the properties relevant for the rotor position control. It is concluded that an increase in pole count, a reduction in bore diameter and an increase in magnet height reduce the undesired parasitic lateral rotor forces, caused by rotor eddy currents and armature reaction. In order to investigate scaling effects, an analytical calculation is used, where the focus is set on the two-dimensional electrodynamic field calculation. By means of a 1 kW / 60000 rpm-prototype drive, consisting of a bearingless machine and a combined active radial-axial magnetic bearing, the accuracy of the results from calculation and simulation is verified. In order to reduce the number of required power electronic half-bridges, a concept is investigated, in which the axial magnetic bearing is supplied by a current between the star points of the combined winding sections in the bearingless machine. To do so the concept of the widely used space vector pulse-width modulation for 3-phase systems is extended to a double 3-phase system in a way that the axial magnetic bearing current corresponds to the sum current in the star point of one 3-phase system. This current can be controlled by the variation of the two star point electric potentials. However, additional current oscillations in the axial bearing current and in the 3-phase current can occur if the inverter is operated close to its voltage limit or if relatively high axial bearing currents must be provided at high dynamics. Anyway, the concept is considered a promising approach, since in this application as turbo-charger drive the disturbing effects do not occur