UREĐIVANJE SNOPA KOD GAĐANJA TOPNIČKOM POSTROJBOM

U okviru završnog rada prikazana je struktura i postupak vođenja topničke bitnice te je objašnjen rad paljbenog dijela topničke postrojbe na paljbenom položaju za posredno gađanje. Poseban naglasak je stavljen na uređenje snopa prilikom gađanja topničke postrojbe, gdje je opisana oprema i potrebni koraci pri određivanju snopa uz pomoć snopara M57. Svrha samog uređivanja snopa je od „velikog oružja“ učiniti precizno i smrtonosno oružje čak i na velikim udaljenostima. Na kraju rada se nalazi obrazac uz pomoć kojeg se računski mogu prikazati podaci za korekciju pojedinih oružja na paljbenom položaju, a koji zamjenjuje snopar. Važno je da proračuni koji se rade sukladno dobivenim podacima sa promatračnice od prednjih topničkih motritelja budu što točniji kako bi i sami pogoci bili što bolji.As part of the final work, the structure and procedure of conducting an artillery battalion are presented, and the work of the firing part of an artillery unit at the firing position for indirect shooting is explained. Special emphasis was placed on the arrangement of the beam when firing artillery units, where the equipment and the necessary steps in determining the beam with the help of the M57 beamer are described. The purpose of editing the beam itself is to make a "big weapon" a precise and deadly weapon, even at great distances. At the end of the work, there is a form with the help of which data for the correction of individual weapons in the firing position can be calculated, which replaces the beam. It is important that the calculations made in accordance with the data obtained from the observation post from the front artillery observers be as accurate as possible so that the hits themselves are as good as possible