High Gradient Magnetic Separation of nanoscale magnetite.

Master of ScienceDepartment of Civil EngineeringAlexander P. MathewsNanoscale magnetite is being examined for possible uses as an adsorbent of heavy metals and for the enhancement of water treatment processes such as stripping of trichloroethylene (TCE) from contaminated water supplies and wastewaters. Methods for recovering nanoscale magnetite must be developed before the particles can be used in water treatment processes. This is necessary because expelling high amounts of particles into the environment will be unacceptable and costly; if captured they can be reused; additionally, they could potentially cause environmental impacts due to their stability in an aqueous environment and possible toxicity. Nanoscale magnetite is superparamagnetic, so it has a high magnetic susceptibility, and hence it is very attracted to magnetized materials. Utilizing the magnetic properties of magnetite may be one possible means of separating the particles from a treatment process. High Gradient Magnetic Separation (HGMS) has been studied for the separation of micron and even tenths of a micron size particles, but there is little experimental data for HGMS of nanoscale magnetite. This research looks to filter nanoscale magnetite through a HGMS and determine the capture efficiency of the filter. Subsequently, the filter was backwashed to determine particle recover efficiencies. The flow rate was adjusted to determine the dependency of particle capture efficiency on cross sectional velocity through the filter. Additionally, particle loading was changed to better understand the correlation of particle loading with capture efficiency. Filtrations for nanoscale magnetite dispersed with sodium tripolyphosphate were also completed as well as filtrations of nanoscale magnetite coated with silica and magnetite silica composites. Experimental data in this research indicates that magnetite nanoparticles can be captured at 99.8% efficiency or higher in a well-designed filtration system. Capture efficiencies around 99.8% have been found for magnetite. The silica coated magnetite and magnetite silica composites were captured at efficiencies as high as 96.7% and 97.9%, respectively. The capture efficiency of the dispersed magnetite is lower than non-dispersed magnetite and most promising at relatively low fluid flow velocities and particle loadings. The maximum capture efficiency for dispersed magnetite particles was 90.3%. Both magnetite and dispersed magnetite were successfully recovered using backwash at pH of 10 to 11