The initial analysis of the aerodynamic characteristics of a 3D printed model of an aircraft

The aerodynamic research into models of an aircraft aims at creating the main characteristics of aerodynamic forces and moments and the aerodynamic characteristics of coefficients of aerodynamic forces and moments, based on real dimensions. The method of 3D printing was used to create a model of an aircraft. The model with the previously set printing parameters and commands for a 3D printer, in the right order, was imported into MakerBot Print. The final stage was printing the model. The printed components of the model of an aircraft were imperfect due to the incorrectly set printing parameters. The model with the previously set printing parameters and commands for a 3D printer, in the right order, was imported into MakerBot Print. The final stage was printing the model. The printed components of the model of an aircraft were imperfect due to the incorrectly set printing parameters. The printing parameters were corrected in the next printing sessions so the surfaces of the components were good enough and grinding was unnecessary. Some excess material was removed in each of the printed components, and the slots were cleaned. Then, the individual models were put together. The article describes the technique of creating a model of an aircraft to map its exact geometry for experimental wind tunnel research. 3D printing enables us to experimentally investigate a created geometry, in particular to investigate further prior to releasing an aircraft to service. The 3D model employs the model created in line with the previous CFD analysis