A centering technique for cast-iron moulds in horizontal centrifugal casting

In this paper, a technique of axial centering of cast-iron moulds, c.g. the so-called "rail system" as suggested by KonCAD CZ s.r.o. for the application of horizontal centrifugal metal casting process. was described, evaluated, and finally not recommended for practical use. The proposed principle of the axial centering technique is based on the fact that two rings with the external shape similar to the shape of the Vignole (flat-bottomed) rail arc welded on the cast-iron mould external perimeter, perpendicularly to the cast-iron longitudinal centreline. The cast-iron moulds are supported by two pairs of opposite conic rollers. The cast-iron mould is driven by a contact power transmission, i.e. by the friction method employing a pair of conical rollers and acting over the welded rings to the cast-iron mould. The circumferential force transfer is carried out by the friction between the cast-iron mould rings and the two driving rollers. Both driving and driven rollers have similar shapes, analogous to a tyred wheel profile. The two driving rollers are tightly fit on the common drive shaft. the centreline of which runs in parallel with the cast-iron mould longitudinal centreline. The necessity of creating of a sufficient thrust force of the cast-iron mould against the rollers causes wear conditions at the rounding of external shapes of rings, bearings, as well as roller contact conic surfaces.Web of Science151171