Accuracy of Sentinel-1 PSI and SBAS InSAR Displacement Velocities against GNSS and Geodetic Leveling Monitoring Data

Correct use of multi-temporal Interferometric Synthetic Aperture Radar (InSAR) datasets to complement geodetic surveying for geo-hazard applications requires rigorous assessment of their precision and accuracy. Published inter-comparisons are mostly limited to ground displacement estimates obtained from different algorithms belonging to the same family of InSAR approaches, either Persistent Scatterer Interferometry (PSI) or Small BAseline Subset (SBAS); and accuracy assessments are mainly focused on vertical displacements or based on few Global Navigation Satellite System (GNSS) or geodetic leveling points. To fill this demonstration gap, two years of Sentinel-1 SAR ascending and descending mode data are processed with both PSI and SBAS consolidated algorithms to extract vertical and horizontal displacement velocity datasets, whose accuracy is then assessed against a wealth of contextual geodetic data. These include permanent GNSS records, static GNSS benchmark repositioning, and geodetic leveling monitoring data that the National Institute of Statistics, Geography, and Informatics (INEGI) of Mexico collected in 2014−2016 in the Aguascalientes Valley, where structurally-controlled land subsidence exhibits fast vertical rates (up to −150 mm/year) and a non-negligible east-west component (up to ±30 mm/year). Despite the temporal constraint of the data selected, the PSI-SBAS inter-comparison reveals standard deviation of 6 mm/year and 4 mm/year for the vertical and east-west rate differences, respectively, thus reassuring about the similarity between the two types of InSAR outputs. Accuracy assessment shows that the standard deviations in vertical velocity differences are 9−10 mm/year against GNSS benchmarks, and 8 mm/year against leveling data. Relative errors are below 20% for any locations subsiding faster than −15 mm/year. Differences in east-west velocity estimates against GNSS are on average −0.1 mm/year for PSI and +0.2 mm/year for SBAS, with standard deviations of 8 mm/year. When discrepancies are found between InSAR and geodetic data, these mostly occur at benchmarks located in proximity to the main normal faults, thus falling within the same SBAS ground pixel or closer to the same PSI target, regardless of whether they are in the footwall or hanging wall of the fault. Establishing new benchmarks at higher distances from the fault traces or exploiting higher resolution SAR scenes and/or InSAR datasets may improve the detection of the benchmarks and thus consolidate the statistics of the InSAR accuracy assessments