Bandwidth-Based Wake-Up Radio solution through IEEE 802.11 technology

IEEE 802.11 consists of one of the most used wireless access technologies, which can be found in almost all consumer electronics devices available. Recently, Wake-up Radio (WuR) systems have emerged as a solution for energy-efficient communications. WuR mechanisms rely on using a secondary low-power radio interface that is always in the active operation mode and is in charge of switching the primary interface, used for main data exchange, from the power-saving state to the active mode. In this paper, we present a WuR solution based on IEEE 802.11 technology employing transmissions of legacy frames by an IEEE 802.11 standard-compliant transmitter during a Transmission Opportunity (TXOP) period. Unlike other proposals available in the literature, the WuR system presented in this paper exploits the PHY characteristics of modern IEEE 802.11 radios, where different signal bandwidths can be used on a per-packet basis. The proposal is validated through the Matlab software tool, and extensive simulation results are presented in a wide variety of scenario configurations. Moreover, insights are provided on the feasibility of the WuR proposal for its implementation in real hardware. Our approach allows the transmission of complex Wake-up Radio signals (i.e., including address field and other binary data) from legacy Wi-Fi devices (from IEEE 802.11n-2009 on), avoiding hardware or even firmware modifications intended to alter standard MAC/PHY behavior, and achieving a bit rate of up to 33 kbps.Postprint (published version