CUHK electronic theses & dissertations collection

Chitin is known as an effective biosorbent, which is used to preconcentrate PCP for further treatment. In order to reuse and recover the biosorbent, magnetic separation is a cost-effective alternative to separate the PCP-adsorbed biosorbent (i.e. chitin) from the treated water. Therefore, chitin is immobilized by magnetite prior PCP adsorption. From the immobilization results, the solution pH, temperature, agitation rate do not show great effect on the immobilization of chitin and magnetite. Second, magnetite-immobilized chitin can be formed as quickly as 5 min. Moreover, the interaction of chitin and magnetite is very strong since it is not easy to separate by vigorous shaking, high temperature and changing pH. Although the underlying mechanism of magnetite and chitin is still obscure, the biosorbent is proved to have high stability and reusability. In addition, both Langmuir and Freundlich models indicate that immobilization of chitin by magnetite is favorable with the Langmuir model being the major one.For PCP adsorption study, it is found that magnetite-immobilized chitin can retain the PCP adsorption ability as free chitin. In accordance with the results, the PCP adsorption of magnetite-immobilized chitin is influenced by altering the parameters of biosorbent concentration, solution pH, temperature, agitation rate, contact time and initial PCP concentration. In general, higher amount of biosorbent gives higher removal efficiency (RE) but lower removal capacity (RC) as more binding sites are available for PCP. The PCP removal is enhanced by lowering pH since uncharged PCP is favorable for adsorption. It is speculated that hydrophobic interaction, hydrogen bonding and electrostatic interaction are involved. In addition, the biosorption efficiency is impeded by high temperature. Evidence shows that the adsorption might be due to the exothermic force such as hydrogen bonding. The biosorption is described as biphasic mechanism with the fast initial phase followed by slow equilibrium phase. For the PCP (10 mg/L) adsorption, the optimized conditions are: 1,500 mg/L of magnetite-immobilized chitin, initial pH 6, 25°C, 200 rpm and 60 min. The RE is 57.9% and RC is 5.4 mg/g. However, the increase in the amount of immobilized chitin (24,000 mg/L) can increase the RE up to 98%. By considering the Langmuir and Freundlich isotherms, the adsorption might be heterogenous, as the correlation coefficient from Freundlich model is higher.Pentachlorophenol (PCP), a highly chlorinated aromatic organic compound, was widely used as a biocide and is now restrictly used as a wood preservative. PCP is toxic and ubiquitous environmental pollutant. In the present study, integrated treatment of biosorption and photocatalytic oxidation (PCO) using magnetite-immobilized chitin is employed to completely degrade PCP.To thoroughly remove PCP, PCO is also employed after the biosorption. One hundred % of PCP removal is achieved after 5 h irradiation time, in 100 mL solution at initial pH 9 with 20 mM of H2O2 and 200 mg/L of TiO2. The intermediates of PCP are identified as 2,3,5,6-tetrachlorohydroquinone (TeHQ) and 2,3,5,6-tetrachlorophenol (TeCP) by GC/MS analysis. In addition, the toxicity of sample is monitored by the solid-phase and aqueous-phase Microtox RTM tests, which the toxicity increases and then decreases along the irradiation time. The biosorbent shows no great changes on chitin content and functional groups after PCO. In addition, the results imply that magnetite-immobilized chitin has a good potential to be reused at least for four cycles with high RE and DE. Therefore, the combination of biosorption and PCO treatment was feasible for PCP removal and the system is economic and convenient for repeated use.by Pang, King Man."Oct 2007."Source: Dissertation Abstracts International, Volume: 69-08, Section: B, page: 4636.Thesis (Ph.D.)--Chinese University of Hong Kong, 2007.Includes bibliographical references (p. 186-212).Electronic reproduction. Hong Kong : Chinese University of Hong Kong, [2012] System requirements: Adobe Acrobat Reader. Available via World Wide Web.Electronic reproduction. [Ann Arbor, MI] : ProQuest Information and Learning, [200-] System requirements: Adobe Acrobat Reader. Available via World Wide Web.Abstracts in English and Chinese.School code: 1307