Toward UV-Triggered Curing of Solvent-Free Polyurethane Adhesives Based on Castor Oil

An o-nitrobenzyl-protected precursor was used as a phototrigger for the release of the diamine cadaverine in polyurethane adhesives based on castor oil as a renewable source of polyol and organic diisocyanates. This resulted in formulations with suitably controlled curing by photoactivation. This material shows faster curing when UV light is applied as compared to curing in the absence of irradiation, which was in situ monitored by rheological measurements. In addition, the adhesion performance is superior, reaching lap shear strength values of up to 4600 kPa, which is unprecedented for bio-based adhesives. On one hand, the in-depth chemical characterization with FTIR spectroscopy revealed that the slow release of cadaverine yields a well-balanced urethane/urea composition with direct impact on adhesion properties. The photocured bioadhesive was shown to bond a variety of surfaces, such as polyethylene or even wood. On the other hand, the direct one-time addition of cadaverine yields a material with approximately the same viscoelastic properties, which were achieved almost immediately as a consequence of the favored fast formation of urea bonds in detriment of urethanes, however, lacking adhesion properties.University of Huelva, in the frame of the European Regional Development Fund (ERDF)-Junta de Andalucía 2014−2020 Operational Programme. Ministerio de Educación, Cultura y Deporte (FPU16/ 03697) Funding for open acess charge: Universidad de Huelva/CBUAWe are grateful for financial support through the project UHU-1252599, financed by the University of Huelva, in the frame of the European Regional Development Fund (ERDF)-Junta de Andalucía 2014−2020 Operational Programme. A.M.B.-L. acknowledges the Spanish Ministerio de Educación, Cultura y Deporte for the award of a doctoral fellowship (FPU16/03697).Funding for open access charge: Universidad de Huelva / CBU