Production of bacterial cellulose nanocrystals via enzymatic hydrolysis and evaluation of their coating on alginate particles formed by ionotropic gelation

This study aimed to obtain the bacterial cellulose nanocrystals (CNC) by enzymatic hydrolysis and verify the CNC application as coating material in alginate particles. Therefore, the production of CNC was carried out through two enzymatic hydrolysis methods involving a time period of 48 and 72 h. 0.35 mg of dry mass of cellulose was produced approximately 1.6 × 1011 CNC/mL. The CNC obtained by enzymatic hydrolysis at 72 h (Method II) was applied to cover the alginate particles, obtained by ionotropic gelation. The CNC Zeta potential value was about +15 mV and for alginate particles -26.46 ± 1.48 mV. These results confirmed the application of CNC as coating material for alginate particles. It brings an incremental contribution to the knowledge advancement in the pharmaceutical and food area, allowing the engineering of systems to use a mixed composition of nanobiomaterials to modify the release pattern of drugs, macromolecule, nutrients, stabilizers and target specific drug release.The authors acknowledge financial support from Coordination for Higher Level Graduate Improvements (CAPES/Brazil, Grant Numbers 001), National Council for Scientific and Technological Development (CNPq/Brazil), and the State of São Paulo Research Foundation (FAPESP/Brazil, grant numbers 2019/22,626–5 and 2018/10,508–5).