Yaşlandırılabilir alüminyum alaşımlarının aşırı plastik deformasyonu.

Industrial products of high-strength Al-alloys are currently manufactured by thermo-mechanical processes, which are only applicable in the integrated plants requiring high investment cost. Moreover, reduction of the average grain size not less than 10 μm and re-adjustment of process parameters for each alloy type is evaluated as disadvantage. Therefore, recently there have been many research studies for development of alternative manufacturing techniques for aluminum alloys. Research activities have shown that it is possible to improve the strength of Al-alloys remarkably by severe plastic deformation which results in ultra-fine grain size. This study aims to design and manufacture the laboratory scale set-ups for severe plastic deformation of aluminum alloys, and to characterize the severely deformed samples. The stages of the study are summarized below: First, for optimization of die design and investigation of parameters affecting the deformation finite element modeling simulations were performed. The effects of process parameters (die geometry, friction coefficient) and material properties (strain hardening, strain-rate sensitivity) were investigated. Next, Equal Channel Angular Pressing (ECAP) system that can severely deform the rod shaped samples were designed and manufactured. The variations in the microstructure and mechanical properties of 2024 Al-alloy rods deformed by ECAP were investigated. Finally, based on the experience gained, a Dissimilar Channel Angular Pressing (DCAP) system for severe plastic deformation of flat products was designed and manufactured; then, 6061 Al-alloy strips were deformed. By performing hardness and tension tests on the strips that were deformed by various passes, the capability of the DCAP set-up for production of ultra-fine grain sized high-strength aluminum flat samples were investigated.Ph.D. - Doctoral Progra