Performance Investigation of MQL Parameters Using Nano Cutting Fluids in Hard Milling

Machining difficult-to-cut materials is one of the increasingly concerned issues in the metalworking industry. Low machinability and high cutting temperature generated from the contact zone are the main obstacles that need to be solved in order to improve economic and technical efficiency but still have to ensure environmental friendliness. The application of MQL method using nano cutting fluid is one of the suggested solutions to improve the cooling and lubricating performance of pure-MQL for machining difficult-to-cut materials. The main objective of this paper is to investigate the effects of nanofluid MQL (NFMQL) parameters including the fluid type, type of nanoparticles, air pressure and air flow rate on cutting forces and surface roughness in hard milling of 60Si2Mn hardened steel (50–52 HRC). Analysis of variance (ANOVA) was implemented to study the effects of investigated variables on hard machining performance. The most outstanding finding is that the main effects of the input variables and their interaction are deeply investigated to prove the better machinability and the superior cooling lubrication performance when machining under NFMQL condition. The experimental results indicate that the uses of smaller air pressure and higher air flow rate decrease the cutting forces and improve the surface quality. Al2O3 nanoparticles show the better results than MoS2 nanosheets. The applicability of soybean oil, a type of vegetable oil, is proven to be enlarged in hard milling by suspending nanoparticles, suitable for further studies in the field of sustainable manufacturing