Analysis and Simulation of Polymer Injectivity Test in a High Temperature High Salinity Carbonate Reservoir

Polymer flooding has gained much interest within the oil industry in the past few decades as one of the most successful chemical enhanced oil recovery (CEOR) methods. The injectivity of polymer solutions in porous media is a key factor in polymer flooding projects. The main challenge that faces prediction of polymer injectivity in field applications is the inherent non-Newtonian behavior of polymer solutions. Polymer in situ rheology in porous media may exhibit complex behavior that encompasses shear thickening at high flow rates in addition to the typical shear thinning at low rates. This shear-dependent behavior is usually measured in lab core flood experiments. However, data from field applications are usually limited to the well bottom-hole pressure (BHP) as the sole source of information. In this paper, we analyze BHP data from field polymer injectivity test conducted in a Middle Eastern heterogeneous carbonate reservoir characterized by high-temperature and high-salinity (HTHS) conditions. The analysis involved incorporating available data to build a single-well model to simulate the injectivity test. Several generic sensitivities were tested to investigate the impact of stepwise variation in injection flow rate and polymer concentration. Polymer injection was reflected in a non-linear increase in pressure with injection, and longer transient behavior toward steady state. The results differ from water injection which have linear pressure response to rate variation, and quick stabilization of pressure after rate change. The best match of the polymer injection was obtained with complex rheology, that means the combined shear thickening at high rate near the well and moving through apparent Newtonian and shear thinning at low rate.publishedVersio