LEVERAGING INVERTER-INTERFACED ENERGY STORAGE FOR FREQUENCY CONTROL IN LOW-INERTIA POWER SYSTEMS

The shift from conventional synchronous generation to renewable inverter-interfaced sources has led to a noticeable degradation of frequency dynamics in power systems, mainly due to a loss of inertia. Fortunately, the recent technology advancement and cost reduction in energy storage facilitate the potential for higher renewable energy penetration via inverter-interfaced energy storage. With proper control laws imposed on inverters, the rapid power-frequency response from energy storage contributes to mitigating the degradation. A straightforward choice is to emulate the droop response and/or inertial response of synchronous generators through droop control (DC) or virtual inertia (VI), yet they do not necessarily fully exploit the benefits of inverter-interfaced energy storage. This thesis thus seeks to challenge this naive choice of mimicking synchronous generator characteristics by advocating for a principled control design perspective. To achieve this goal, we build an analysis framework for quantifying the performance of power systems using signal and system norms, within which we perform a systematic study to evaluate the effect of different control laws on various performance metrics. Our analysis unveils several limitations of traditional control laws, such as the coupling between the steady-state performance and dynamic performance in DC and the high noise sensitivity of VI, which motivate the need for better solutions. We first propose dynam-i-c Droop control (iDroop) which is proved to enjoy many good properties. First, iDroop is able to decouple the steady-state performance and dynamic performance. Moreover, iDroop can be tuned to achieve Nadir elimination, zero synchronization cost, and low noise sensitivity. However, iDroop has no control over the rate of change of frequency (RoCoF), which is undesirable in low-inertia power systems for the risk of falsely triggering protections. We then propose frequency shaping control (FS) whose most outstanding feature is its ability to shape the system frequency dynamics following a sudden power imbalance into a first-order one with the specified synchronous frequency and RoCoF by adjusting two independent control parameters. We finally validate theoretical results through numerical experiments performed on a more realistic power system test case that violates the proportionality assumption