The temperature rise obtained from the separate excitation loss and rated current method -- Excitation losses and the open circuit test -- Temperature rise measurement for the excitation losses -- Experimental results for open circuit test -- Load losses and short circuit test -- Temperature rise measured for load losses -- Experimental results for short circuit test -- Calculation of the total winding temperature rise -- The total temperature rise obtained from the loading back method -- Analysis of the loading back method -- The total temperature rise measured form loading back method -- Experimental results for loading back method -- Comparison of temperature rise from two experimental methods -- The total temperature rise obtained from ...
This master’s thesis project is a part of the Sinergie project (sponsored by Agentschap NL, 2007-201...
Since the distribution transformers are widely used in industry, many variables, including materials...
Temperature is one of the limiting factors in the application of power transformers. According to IE...
Thermal behavior of the transformers is affected by distorted loads caused by the influence of elect...
Dry-type transformers play an important role and are used everywhere in our life, especially places ...
Tez (Doktora) -- İstanbul Teknik Üniversitesi, Fen Bilimleri Enstitüsü, 2002Thesis (PhD) -- İstanbul...
The discovery of High Critical Température superconductors in 1986 restarts the interest put on supe...
This dissertation presents and analyzes the results of theoretical investigations and experimental o...
In countries with a high ambient temperature and strong solar irradiation, transformer winding hot-s...
Object of research: development of a technology for determining the temperature of the winding of a ...
From Wiley via Jisc Publications RouterHistory: received 2021-02-01, rev-recd 2021-07-08, accepted 2...
The nature of electric power generation, transmission and distribution systems frequently faces high...
A transformer is a device that usually has at least two windings and converts voltage from a level t...
The paper presents a study on thermal behavior of a coil made of a high-temperature supercon-ducting...
This thesis investigates a promising and mature technology: Dynamic Thermal Ratings (DTR) of mineral...
This master’s thesis project is a part of the Sinergie project (sponsored by Agentschap NL, 2007-201...
Since the distribution transformers are widely used in industry, many variables, including materials...
Temperature is one of the limiting factors in the application of power transformers. According to IE...
Thermal behavior of the transformers is affected by distorted loads caused by the influence of elect...
Dry-type transformers play an important role and are used everywhere in our life, especially places ...
Tez (Doktora) -- İstanbul Teknik Üniversitesi, Fen Bilimleri Enstitüsü, 2002Thesis (PhD) -- İstanbul...
The discovery of High Critical Température superconductors in 1986 restarts the interest put on supe...
This dissertation presents and analyzes the results of theoretical investigations and experimental o...
In countries with a high ambient temperature and strong solar irradiation, transformer winding hot-s...
Object of research: development of a technology for determining the temperature of the winding of a ...
From Wiley via Jisc Publications RouterHistory: received 2021-02-01, rev-recd 2021-07-08, accepted 2...
The nature of electric power generation, transmission and distribution systems frequently faces high...
A transformer is a device that usually has at least two windings and converts voltage from a level t...
The paper presents a study on thermal behavior of a coil made of a high-temperature supercon-ducting...
This thesis investigates a promising and mature technology: Dynamic Thermal Ratings (DTR) of mineral...
This master’s thesis project is a part of the Sinergie project (sponsored by Agentschap NL, 2007-201...
Since the distribution transformers are widely used in industry, many variables, including materials...
Temperature is one of the limiting factors in the application of power transformers. According to IE...