Development of New No-Flow Underfill Materials for Both Eutectic Sn-Pb Solder and a High Temperature Melting Lead-Free Solder

©2003 IEEE. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or distribution to servers or lists, or to reuse any copyrighted component of this work in other works must be obtained from the IEEE. This material is presented to ensure timely dissemination of scholarly and technical work. Copyright and all rights therein are retained by authors or by other copyright holders. All persons copying this information are expected to adhere to the terms and constraints invoked by each author's copyright. In most cases, these works may not be reposted without the explicit permission of the copyright holder.In recent years, no-flow underfill technology has drawn more attention due to its potential cost-savings advantages over conventional underfill technology, and as a result several no-flow underfill materials have been developed and reported. However, most of these materials are not suitable for lead-free solder, such as Sn/Ag (m.p. 225°C), Sn/Ag/Cu (m.p. 217°C), applications that usually have higher melting temperatures than the eutectic Sn-Pb solder (m.p. 183°C). Due to the increasing environmental concern, the demand for friendly lead-free solders has become an apparent trend. This paper demonstrates a study on two new formulas of no-flow underfill developed for lead-free solders with a melting point around 220°C. As compared to the G25, a no-flow underfill material developed in our research group, which uses a solid metal chelate curing catalyst to match the reflow profile of eutectic Sn-Pb solder, these novel formulas employ a liquid curing catalyst thus provides ease in preparation of the no-flow underfill materials. In this study, curing kinetics, glass transition temperature (Tg), thermal expansion coefficient (TCE), storage modulus (E [superscript v]) and loss modulus (E″) of these materials were studied with a differential scanning calorimetry (DSC), a thermo-mechanical analysis (TMA), and a dynamic-mechanical analysis (DMA), respectively. The pot-life in terms of viscosity of these materials was characterized with a stress rheometer. The adhesive strength of the materials on the surface of silicon chips were studied with a die-shear instrument. The influences of fluxing agents on the materials curing kinetics were studied with a DSC. The materials compatibility to the solder penetration and wetting on copper clad during solder reflow was investigated with both eutectic Sn-Pb and 95.9Sn/3.4Ag/0.7Cu solders on copper laminated FR-4 organic boards