Analysis of electrogenerated chemiluminescence of PPV type conducting polymers

Electrochemiluminescence (ECL) has been generated in solution phase using 9,10-diphenylanthracene (DPA) with TEAClO4 (or TBAClO4) in acetonitrile solvent. Triple potential step was used for the generation of ECL. It was found that anodic and cathodic ECL of equal intensities can be generated by proper choice of potential step magnitude, width and the waiting period (tw) between successive triple potential steps. ECL was then generated in conducting polymers poly(2-ethylhexyloxy-5-methoxy-1,4-phenylenevinylene) (MEH-PPV) and poly(2,3-dibutoxy-1,4-phenylenevinylene) (DB-PPV) by coating them on Pt electrodes and subjecting to potential steps in tetraalkylammonium salt solutions with acetonitrile. Similar to the case of solution phase ECL, symmetrical anodic and cathodic ECL could be observed by the appropriate choice of the potential step parameters. But the kinetics of the ECL was found to be different from that of the solution phase ECL. The time scale of the ECL process was found to be longer than that in the solution phase ECL. The nature of supporting electrolyte had a remarkable impact on the electrochemistry of conducting polymers. The reasons were analyzed by theoretical calculations evoking the concept of charge transport characteristics of conducting polymers. The rate constants of the ECL process were calculated by separate simulation procedure in the solution phase as well as in the polymer phase ECL. To enhance the stability of conducting polymers, synchrotron radiation induced cross-linking was performed. The effects were different from expected which were analyzed and rationalized by ex-situ Raman spectroscopic studies