Study of Sterilization Effects Initiated by Dielectric Barriere Discharge

The overall goal of the presented dissertation thesis was to study the sterilization efficiency of dielectric barrier discharge operated at atmospheric pressure. The fungi Aspergillus niger, gram-positive bacteria Bacillus subtilis and in some experiments also gram-negative bacteria Escherichia coli were used as a bio-indicator enabling to evaluate the effect of plasma assisted microbial inactivation. The samples of microorganism were placed on paper Whatman 1 or PET foil and exposed to plasma. The plasma was generated in argon, nitrogen, synthetic dry/humid air with frequency up to 10 kHz and plasma power density in the range of 1,2-2,9 W/cm3 (according to the process gas). The influence of process gas, plasma power density, plasma exposition time, type of microorganism and material of the substrate on the sterilization effect of dielectric barrier discharge was evaluated. Furthermore the contribution of each single mechanism (UV radiation, temperature and reactive species) to the sterilization effect of plasma and influence of gas humidity was evaluated. The DBD was analysed by means of optical emission spectroscopy, thermocouple was used to measure temperature during a sterilization process. In order to verify the mechanical damage of the microbial cell or the substrates during the plasma process the samples were studied by scanning electron microscopy. Generally, on the basis of experimental results, at increasing treatment times, the remaining number of spores (CFU) decreased. Similarly at increasing the plasma power input, the sterilization rate increased. When sterilising the spores of A. niger in plasma using different process gasses, the efficiency of plasma sterilization decreased as follows: argon, humid synthetic air, nitrogen and dry synthetic air. The results observed in argon plasma using different microorganism demonstrated that the sensitivity of vegetative cells resp. spores to DBD decreased as follows: A. niger spores, B. subtilis vegetative cells, E. coli vegetative cells and B. subtilis spores. Simultaneously results observed for sterilization of spores and vegetative cells of B. subtilis and A. niger demonstrated that the spores are generally more resistant to plasma than are the corresponding vegetative cells. Combining the results of contribution of each single mechanism, optical emission spectroscopy and inactivation characteristic it was found out that the reactive species significantly contribute to the plasma sterilization in all process gasses. Furthermore the inactivation process can be partly assisted by UV radiation and also the temperature can contribute in limited extent to inactivation process in some gasses. The contribution of UV radiation to the plasma sterilization decreased as follows: nitrogen, argon, dry syntetic air and humid syntetic air. Moreover it was found out that the contribution of each single mechanism can be species dependent, this is due to the different response of microorganism to the unfavorable external conditions. SEM analysis of the substrates prooved the etching actions of the plasma generated in all process gasses on the surface of the PET foil. The several minute plasma exposition of the PET foil resulted in the occurence of the „hole corrosion“ on the PET surface. Contrary to these there were no visible changes observed in the paper structure