RF and THz Identification Using a New Generation of Chipless RFID Tags

This article presents two chipless RFID approaches where data are reading using electromagnetic waves and where the medium encoding the data is completely passive. The former approach rests on the use of RF waves (more precisely the ultra-wide band UWB). The tags developed for this application are comparable with very specific, planar, conductive, radar targets where the relation between the tag geometry and its electromagnetic signature is perfectly known and is used to encode the data. The principle of operation as well as the realization process of the RF tags presented in this paper is similar to those already reported in the literature. However, contrary to the majority of chipless RFID tags, these labels do not present an antenna function dissociated from the circuit part where the data are stored. Here, functions such as the receiver, the treatment and the emitter of the signal are closely dependent. The data storage capacity of the RF chipless tags is proportional to of the used frequency bandwidth. As radio spectrum is regulated, the number of possible encoding bits is thus strongly limited with this technology. This is the reason why we introduce a new family of tags radically different from the preceding one, where data is encoded in volume thanks to a multilayer structure operating in the THz domain. These two approaches although different are complementary and allow to increase significantly the data storage capacity of the chipless tags. Simulation and experimental results are reported in this paper for both configurations. We demonstrate a coding capacity of 3.3 bit/cm2 for RFID chipless tags and a potential 10 bits coding capacity in the THz domain