Predicting Soil-Water Characteristic Curves of Clayey Sand Soils Using Area Computation

The soil-water characteristic curves (SWCCs) for soils are important for geotechnical engineers in the prediction of clay behavior in case of partially saturated conditions. In the wastewater and waste containment industry, variable clay content is considered. It is not practical to run a time-consuming test several times to obtain the soil-water characteristic curves for every proportion. This study is aimed at introducing a practical procedure to predict the response of clay of known mineralogy and geological setting when clay content within a liner is variable. Fitting curves were performed using Fredlund and Xing’s (1994) equations. The general trends were established for selected clay of known high content of smectite minerals. Obtained curves were examined, and areas under the suction curve were integrated from the starting point to the inflection point for clay-sand material with 5%, 10%, 15%, 30%, 60%, and 100% clay content. This area can be used to estimate the profile of the SWCC for higher or lower clay content based on an area factor determined for a specific clay type or clay of known mineralogy. Other clay of similar nature, but not typical mineralogy, were compared in order to observe and validate the use of the area method in predicting the SWCC for similar soils