Method for control the mechanical parameters of overhead power lines based on improved inclinometry

Structural elements of overhead power transmission lines are experiencing both horizontal and vertical loads. Wires and cables are elements of the overhead power line, on which changes in mechanical loads are observed to a greater degree. This occurs due to the change in the tension force of the wire/cable depending on the temperature and the formation of icy-rime deposits on it, as well as fluctuations in wind gusts. The article describes the most common systems and methods for determining the mechanical loads on an overhead power transmission line. A method is proposed for calculating the mechanical loads on an overhead transmission line based on mathematical models of a flexible wire, rope and a model for determining ice deposits on wires, taking into account the rotation of the wire/cable around its axis. A comparison of the improved inclinometry method with the method developed earlier for the case of formation of ice deposits on the S-50 cable has been carried out. A comparison was made on the error in determining the tension of the S-50 ground-wire protection cable using the method developed to control the mechanical parameters of overhead power lines, which takes into account the wire/cable rotation around its axis and the method for determining icy-rime deposits developed earlier. The developed method allows determining the elongation of the wire/cable in the span with one anchor support, as well as the strength of its tension with greater accuracy. However, additional clarification is required due to the influence of the wind, the formation of icy-rime deposits of various shapes, as well as the structural limitations of the wire/cable rotation when attaching it to the support