Evaluation of Drinking Water Quality in Rural Area of Amhara Region, Ethiopia: The Case of Mecha District

This study was conducted to assess the drinking water quality of north Mecha district, Amhara Region, Ethiopia. 26 drinking water samples were collected from the water points of the dweller community in the dry seasons of 2020 and subjected to the analysis of physicochemical parameters, bacteriological parameters, and the level of trace metals. The analysis of physicochemical parameters and the trace metals was carried out following the standard procedures of the laboratory, and the bacteriological water qualities were measured using the membrane filtration method. The F−, NO3−, SO42−, and Cu levels of the water samples were within the permissible limits of the WHO and compulsory Ethiopian standard (CES). Depending on turbidity, 61.54% of the tested water samples crossed the WHO limit of drinking water quality, and 100% of the samples surpassed the limits of EPA. Based on iron and ammonia levels, 38.46%, and 100% of the studied water samples violated the environmental protection agency (EPA) guidelines; 23.07%, and 3.84%, of the samples surpassed the WHO and CES drinking water quality standards. In view of pH, 23.07% of the tested water samples were not within the safe limit of the WHO and CES. 92.31% of the studied water samples were not potable as coliform bacterium (thermo tolerant indicator bacterium) growth was detected. The study revealed that the water sources of the study area are not safe for drinking unless appropriate treatment measurements are taken. Higher values of water quality parameters for the water samples from Koga irrigation site than the values for the water samples from the study sites found out of the irrigation site indicated the pollution load of Koga irrigation on the water quality of the area