Add to ORKGThesis (M.S.)--Massachusetts Institute of Technology, Dept. of Aeronautics and Astronautics, 1991.Includes bibliographical references (leaves 56-57).by Scott Andrew Barton.M.S
A ground test stand was used to obtain acoustic data on a full scale prototype fan designed for quie...
The performance of a conventional engine/inlet installation, in which inlet and engine flow field in...
Results of acoustic tests of three 62.2 cm (24.5 inch) diameter models of the prop-fan (a small diam...
Thesis (Nav. E.)--Massachusetts Institute of Technology, Dept. of Ocean Engineering, 1993, and Thesi...
The operating characteristics of a conventional centrifugal pump have been investigated, both theore...
March 1997Includes bibliographical references (pages 169-190)This report examines the influence of i...
Sources of noise in a 1.4 m (4.6 ft) diameter subsonic tip speed propulsive fan running statically o...
An experimental investigation to determine the possibility of using refracting flows for the suppres...
Thesis (M.S.)--Massachusetts Institute of Technology, Dept. of Aeronautics and Astronautics, 1997.In...
Oil hydraulics is widely accepted as the best technology for transmitting power in many engineering ...
Thesis (S.M.)--Massachusetts Institute of Technology, Dept. of Aeronautics and Astronautics, 2000.In...
Thesis (Ph. D.)--Massachusetts Institute of Technology, Dept. of Aeronautics and Astronautics, 2011....
Wind speed measurements obtained from research ships are prone to systematic errors caused by the di...
A computational study was conducted to understand the influence of aircraft inlet distortion flow on...
A new centrifugal pump has been devised to handle two-phase flow. However, it requires full scale te...
A ground test stand was used to obtain acoustic data on a full scale prototype fan designed for quie...
The performance of a conventional engine/inlet installation, in which inlet and engine flow field in...
Results of acoustic tests of three 62.2 cm (24.5 inch) diameter models of the prop-fan (a small diam...
Thesis (Nav. E.)--Massachusetts Institute of Technology, Dept. of Ocean Engineering, 1993, and Thesi...
The operating characteristics of a conventional centrifugal pump have been investigated, both theore...
March 1997Includes bibliographical references (pages 169-190)This report examines the influence of i...
Sources of noise in a 1.4 m (4.6 ft) diameter subsonic tip speed propulsive fan running statically o...
An experimental investigation to determine the possibility of using refracting flows for the suppres...
Thesis (M.S.)--Massachusetts Institute of Technology, Dept. of Aeronautics and Astronautics, 1997.In...
Oil hydraulics is widely accepted as the best technology for transmitting power in many engineering ...
Thesis (S.M.)--Massachusetts Institute of Technology, Dept. of Aeronautics and Astronautics, 2000.In...
Thesis (Ph. D.)--Massachusetts Institute of Technology, Dept. of Aeronautics and Astronautics, 2011....
Wind speed measurements obtained from research ships are prone to systematic errors caused by the di...
A computational study was conducted to understand the influence of aircraft inlet distortion flow on...
A new centrifugal pump has been devised to handle two-phase flow. However, it requires full scale te...
A ground test stand was used to obtain acoustic data on a full scale prototype fan designed for quie...
The performance of a conventional engine/inlet installation, in which inlet and engine flow field in...
Results of acoustic tests of three 62.2 cm (24.5 inch) diameter models of the prop-fan (a small diam...