Effect of potential cycling on structure and activity of Pt nanoparticles dispersed on different carbon supports

International audiencePlatinum particles synthesized via the Bonnemann methods were dispersed on two different Vulcan XC72 carbon Supports. One was used after thermal treatment at 400 degrees C under nitrogen atmosphere, the other after oxidation of its Surface by acid leaching using diluted HNO3 in water (1/3). Characterization of the carbon support indicated that HNO3 treatment leads to the decrease of the BET surface and to the increase of the surface acidity of the carbon support. After dispersion of the platinum catalyst, TEM results indicated that the mean particle size was a little higher on the non-oxidized support (Pt/XC72) than that on the functionalized one (Pt/XC72(HNO3)), being 2.5 and 2.0 nm, respectively. However, potential cycles from 0.05 to 1.25 V vs. RHE led to a higher increase of the particle size when catalyst is dispersed on the functionalized support, reaching after 400 potential cycles 5.5 nm against 4.0 nm with the non-functionalized one. The effect of the upper limit (1.0 and 1.25 V vs. RHE) of the potential cycles on the active surface area and on the activity towards the oxygen reduction reaction (orr) was determined for both catalysts. Results indicated that the particle growth was not the main degradation process over the whole duration of the electrochemical experiments, but that dissolution/redeposition (Otswald ripening) was also involved. The predominant role of each degradation process depends on the number of cycles, on the upper potential limit and on the carbon surface state, and could be temporally separated. However, the lower activity towards orr was recorded for the (Pt/XC72(HNO3)) cycled Lip to 1.0 V vs. RHE